V400c
The paper tray outputs printed receipts or vouchers.
Integrated thermal printer
30 lines per second
The contact reader enables communication between the card and the card reader.
Contact reader ISO 14443
The magnetic stripe reader reads the data stored on the magnetic stripe of the card for payment processing.
Magnetic stripe reader track 1/2/3
The display shows instructions and transaction information in clear and colorful form.
3.5" color display
320 x 480 pixels (HVGA)
The chip card reader reads the card data to enable secure payments.
Chip card reader ISO 7816
1-2-3
Technical data
OS/Processor: Cortex A9, 32-bit RISC processor (600 MHz)
Memory: 512 MB RAM/512 MB Flash/32 GB SDRAM
Dimensions (L x W x H): 19 x 8 x 7 cm
Weight: 392 g (without screen protector), 409 g (with screen protector)
Communication: Ethernet, USB, Serial
- Scope of delivery
ATTENTION!
The power supply unit supplied is specially designed for the V400c terminal. Do not use any other power supply unit!
- Commissioning in 4 steps
1. Wiring diagram
First connect your network/DSL and check your router connection. Then connect the network cable to the terminal and to the router. The small plug of the power supply unit is attached to the bottom of the terminal on the far right and only then is the power supply unit connected to the power supply.
2. Inserting or changing the paper roll
Pull the small locking plate upwards, the cover pops up.
Tilt the cover backwards.
Remove the center sleeve of the old paper roll. Remove dust and paper residue from the roll compartment.
Insert the new thermal paper roll as shown in the illustration. The end of the paper should be approx. 5 cm behind the rubber roller.
Close the paper compartment again. The lock must engage audibly.
Please note:Use paper rolls with a maximum diameter of 37 mm and a maximum width of 57 mm. Available in our Accessories shop.
3. Terminal on/off
The terminal starts directly when it is connected to the power supply. It switches itself off when it is disconnected from the power supply.
Only a power supply unit approved by CCV for this type of terminal (with CE mark) may be used.The power supply unit supplies the terminal with the appropriate power. Please ensure that no additional devices are connected to the main device or the power supply unit.Damaged components of the power supply (cables, plugs, etc.) cannot be replaced by the user. In this case, the components must be taken to our maintenance service to carry out the appropriate repairs and/or reinstallation.Please note:The socket outlet for the terminal should be located in an easily accessible place near the point of sale. In the event of danger or a fault, the power supply unit should be disconnected from the mains.
4. Establish Internet connection
The terminal automatically connects to the DSL/router.
Please note:Routers are always supplied with DHCP active in the standard configuration.
DHCP must be active on the router. If this is not the case and the settings of your own router are known, follow the instructions on the next page.
4.1 Connect network/DSL via manual entry (without DHCP)
Please note:The spelling of the IP address on the terminal must be correct.
Example:
Spelling of IP on the router: 192.168.2.1
Spelling of IP on the terminal: 192.168.002.001Please note:The terminal is delivered ready for operation. If this is not the case after checking the DHCP, network/DSL and power connection, please contact our Customer service.
V 400 c V-400c V400c V400-c V/400c