CCV Base Next Commissioning

Start by connecting the terminal to the connection box. Then connect the connection box to the power supply unit and the LAN connection. Finally, connect the power supply unit to the power supply.

The connection box can be attached in different ways. See some examples here:

1. Pull the locking plate upwards, the cover pops open.

2. Tilt the cover backwards.

3. Remove the center sleeve of the old paper roll. Remove dust and paper residue from the roll compartment.

4. Insert the new thermal paper roll as shown in the illustration.
   Unroll the end of the paper 5 cm over the tear-off edge and hold it firmly.

5. Close the paper compartment again. The lock must engage audibly.

The terminal starts automatically when it is connected to the power supply. Please wait until the display prompts you to enter a payment amount.

Alternatively, you can press the cancel button [X] for 3 seconds. Please wait until the display prompts you to enter the amount of a payment.

To switch off the terminal, press the cancel button [X]. Confirm the question "Power off?" with "Yes".
Please wait until the terminal has switched off (display is dark).

The terminal automatically connects to the DSL/router.

The main menu can be called up from the input mode of the terminal by pressing the favorites menu (star symbol).
Then press the menu symbol and enter the corresponding menu PIN.

You can also access all functions via the favorites list, which you can call up by pressing the [*] function button. The functions (symbols) displayed depend on the range of functions of your terminal. It is therefore possible that, in deviation from these instructions, you will have to scroll down (several times) using the down arrow key to reach the desired function.

Transaction type
This main menu provides quick access to all available transaction types. For example, vouchers, cancelations, tip transactions and much more can be started easily.

In the favorites menu (star symbol) you will find all functions relevant for cashiers.

1. Press the favorites menu (star symbol).

2. Then select the arrow key cross symbol.

3. Select the softkey you want to change.

4. Then select the new softkey.

5. The terminal returns to the main screen.

To check the status of the card, you can make a payment for an amount of 0.00. This allows you to check whether the card is active.

For security reasons, it is sometimes necessary to enter the PIN or sign the merchant receipt even for amounts below the limit.

Therefore, please always observe the information on the terminal display and the receipt printouts.

This procedure applies if you have agreed PIN payment with us as part of the payment procedure you have commissioned.

If you have selected payment by SIGNATURE (ELV/OLV), the amount is irrelevant. The signature must be provided depending on the display message.