P400
The contact reader enables communication between the card and the card reader.
Contactless reader ISO 14443 A&B, MiFare
ISO 18092 compatible
The display shows instructions and transaction information in clear and colorful form.
Surface hardened
3.5" TFT color touch display320 x 480 pixels (HVGA)
The magnetic stripe reader reads the data stored on the card's magnetic stripe for payment processing.
Magnetic stripe reader
ISO 7810, 7811, 7813
The chip card reader reads the card data to enable secure payments.
Chip card reader ISO 7816-3
Technical data
OS/Processor: Cortex A9 32-bit RISC/600 MHz
Memory: 1,024 MB (512 MB Flash/512 MB SDRAM)
Dimensions (L x W x H): 16.7 x 8.0 x 5.8 cm
Weight: 329 g
Communication: LAN, USB, Serial
- Scope of delivery
ATTENTION!
The power supply unit supplied is specially designed for the P400 terminal. Do not use any other power supply unit!
- Commissioning in 4 steps
1. Wiring diagram
First connect your network/DSL and check your router connection. Then start by connecting the terminal with the multiport cable. Connect the multiport cable to the router using the network cable and then connect the power supply unit to the power supply.
2. Setting up the cash register connection
2.1 Requirements
Your terminal will be handed over to you already configured by PAYONE. For the data transfer from your LAN to the Internet, to our authorization computer, normally no login is necessary. If special settings (e.g. fixed IP addresses) are required, please contact our customer service, who will make the settings in cooperation with the network administrator (cashier).
Please note:If the terminal needs to be replaced, it is important that our customer service knows the special settings. You will need the IP address and port number of the terminal for the cash register connection.
2.2 Determine the IP address and port number of the terminal
The cash register operator can set up a cash register connection with the determined IP address and I/O port number of the terminal and register the terminal. The entries at the cash register are specific to the cash register. After logging in, the terminal switches to cash register mode. The Information and Main menu fields are no longer displayed.
* Preset password
00 00 00
Please assign new passwords before logging in to the cash register.
3. Switch terminal on/off
The device does not have an on/off switch.
Switching on
Connect the device to the power supply. The software is loaded. The basic status "Please log in" is displayed.
Log the device onto the POS system. The basic status "Terminal ready for operation" is displayed.
Switching off/restarting via softkey (touchscreen key)Log the device off the POS system.
In the initial state, select the Information menu, enter the password (00 00 00) and confirm with the confirmation key [ ]
Confirm with the confirmation key [O].Select the Switch off function.
Select the corresponding function: Switch off and confirm with the confirmation button [O] to confirm/restart and press the confirmation button [O] confirmation button.
4. Establish Internet connection
The device sets up the LAN connection automatically.
P 400 P-400 P400 P/400