CCV Mobile A920 Commissioning

Start by connecting the terminal to the charging cradle. Then connect the charging cradle to the power supply unit and the power supply unit to the power supply.

1. Pull the release forwards, then fold the cover backwards.

2. The cover pops open.

3. Remove the center sleeve of the old paper roll. Remove dust and paper residue from the roll compartment.

4. Insert the new thermal paper roll as shown in the illustration.
   Unroll the end of the paper 5 cm over the tear-off edge and hold it firmly.

5. Close the paper compartment again. The lock must engage audibly.

The terminal starts directly after the [Power] button on the right-hand side of the device is held down for a few seconds.

The terminal is switched off using the same [Power] button, hold it down for 2 seconds.

The [Power] symbol on the display and press the [Power] symbol on the display.

The CCV Mobile A920 terminal is based on the Android operating system and operates accordingly. After the device has been switched on, it boots up and displays the Android home screen.

To enter the card payment mode, on the display SECpos EVO on the display.

Your terminal will be handed over to you already configured by PAYONE. For data transmission in your WLAN (wired network), you will need to log in, which is only possible on site.

For this login you need the following information from your WLAN:

1. WLAN name/SSID
   This is the name with which your network registers via the radio link.

2. WLAN key (WPA2)
   This key (network key) is usually noted on the back of the router. It ensures that no one can gain unauthorized access to your network.

To switch to the WLAN manually, you must activate the WLAN.

Terminal now connects to the router. You can recognize the active WLAN by the WLAN reception quality symbol at the top right of the display.

To switch to GPRS manually, you must deactivate the WLAN.

Terminal will now connect to the mobile network. You can recognize the active network by the Network reception quality sign in the top right-hand corner of the display.

1. After 4 minutes of user activity, the terminal screen goes off automatically.

2. After 15 minutes of user inactivity, the terminal automatically goes into sleep mode.

3. After 120 minutes of user activity, the terminal switches off automatically.

The main menu can be accessed by pressing the right-hand menu function spring (three horizontal strips on top of each other).

You can also access all functions via the favorites list, which you can call up by pressing the [*] function button. The functions (symbols) displayed depend on the range of functions of your terminal. It is therefore possible that, in deviation from these instructions, you will have to scroll down (several times) using the down arrow key to reach the desired function.

Transaction type
This main menu provides quick access to all available transaction types. For example, vouchers, cancelations, tip transactions and much more can be started easily.

In the favorites menu (star symbol) you will find all functions relevant for cashiers.

1. Press the favorites menu (star symbol).

2. Then select the arrow key cross symbol.

3. Select the softkey you want to change.

4. Then select the new softkey.

5. The terminal returns to the main screen.

For security reasons, it is sometimes necessary to enter the PIN or sign the merchant receipt even for amounts below the limit.

Therefore, please always observe the information on the terminal display and the receipt printouts.

This procedure applies if you have agreed PIN payment with us as part of the payment procedure you have commissioned.

If you have selected payment by SIGNATURE (ELV/OLV), the amount is irrelevant. The signature must be provided depending on the display message.